Related Manuals for Argos Jenson
Summary of Contents for Argos Jenson
- Page 1 JENSON Gloss 941/7481 853/5890 Spare Parts Customer Support Visit: www.argos-support.co.uk Call: 0345 640 2020 Email: Help@ClickSpares.co.uk Call: 0330 016 1114 Issue 1 - 11/12/20...
-
Page 2: Care Advice
Safety Important - Please read these instructions fully before starting assembly • WARNING: To prevent • Warning: This unit weighs possible overbalancing this unit approximately 43kgs. must be secured to a wall using Please lift with care. the 2 overbalance protector kits •... -
Page 3: Cabinet Panels
Cabinet Panels Please do NOT remove any protective film until after assembly 42.3 x 42.9cm 42.3 x 42.9cm 42.3 x 41.5cm 46.9 x 41.4cm 46.9 x 6.0cm 42.3 x 41.5cm 49.7 x 41.4cm 49.7 x 6.0cm 147.5 x 36.5cm 149.9 x 45.0cm 49.7 x 39.6cm 49.5 x 32.7cm... - Page 4 Drawer Panels Note: the internal drawer panels are grey Please do NOT remove any protective film until after assembly 49.5 x 32.7cm 40.0 x 14.0cm 40.0 x 14.0cm 44.75 x 39.7cm 43.65 x 14.0cm...
- Page 5 Fittings Use these drawings to correctly identify the fittings Bag 1 x 32 x 16 x 16 x 13 Bag 2 Tools Only used for drilling walls...
- Page 6 Fittings Use these drawings to correctly identify the fittings Tools Only used for drilling walls...
- Page 7 Fitting Ball Bearing Runners www.youtube.com/watch?v=yG4xtiJJeSg Bag 1 x 32 x 16 x 16 x 13 Finished 2nd hole front edge Finished front edge 2nd hole...
- Page 8 Finished front edge Finished front edge...
- Page 9 Finished front edge Fitting Ball Bearing Runners www.youtube.com/watch?v=yG4xtiJJeSg Finished front edge...
- Page 10 2nd hole Finished front edge Finished front edge Finished front edge...
- Page 12 Finished front edge...
- Page 13 Finished front edge Fitting Ball Bearing Runners www.youtube.com/watch?v=yG4xtiJJeSg 2nd hole Finished front edge...
- Page 14 2nd hole Finished front edge Finished front edge...
- Page 16 Finished front edge...
- Page 17 Finished front edge Finished front edge...
- Page 19 Finished front edge...
- Page 20 Squaring up a Chest and fitting the Back Panel www.youtube.com/watch?v=FeaI6541z7o The Back panel must be flush with the Back Rail. A = B Make sure measurement A and B are the same...
- Page 21 x 13 Only use 1 Screw to fit each Bracket Finished front edge...
- Page 22 IMPORTANT: The Back panel must slot into the groove in the Top panel...
- Page 23 WARNING! In order to prevent overturning this product must be used with the 2 wall attachment devices provided See the next section for a guide to wall mounting and fixings Slide the Brackets against the wall. Fit the 2nd screws supplied with the Brackets into the underside of the Top panel.
-
Page 24: A Guide To Wall Mounting & Fixings
A Guide to Wall Mounting & Fixings Important: When drilling into walls always Important note: check that there are no hidden wires or pipes etc. If plastic wall plugs Make sure that the screws and wall plugs being used are supplied with your are suitable for supporting your unit. - Page 26 Pre-mounted Hinge Fitting & Adjustment https://www.youtube.com/watch?v=b4NeCGnpjP8 Press the screws into the holes in the panels When the hinges have been pushed in, tighten up their screws...
- Page 27 Pre-mounted Hinge Fitting & Adjustment https://www.youtube.com/watch?v=b4NeCGnpjP8 Adjust the Door if required Height adjustment. Loosen screws A on Hinge Plates and move Door up or down as required. Retighten screw A. Forward and Back adjustment. Loosen screw B on Hinge Plate and move door in or out as required.
-
Page 28: Drawer Assembly
Drawer Assembly Bag 2 Drawer Assembly www.youtube.com/watch?v=InNBV_uuMmo... - Page 32 Fitting Ball Bearing Runners www.youtube.com/watch?v=yG4xtiJJeSg Warning: Use a Screwdriver to position the Runners as they could have sharp edges Slide both of the Runners forward and locate the Drawer Sides between them, lining up the holes in the Drawer Sides with the 2nd 'threaded' holes in the Runners. Working from the inside of the Drawer, insert 2 Screws through the Drawer Sides and out into the 2nd threaded hole in the Runner.
Need help?
Do you have a question about the Jenson and is the answer not in the manual?
Questions and answers
How do I take the drawers out of the unit once put together