Inspect The Transmission Hydraulic Oil Level - Yanmar SA Series Operation Manual

NOTE
If the engine oil level is low:
●Remove the engine oil filler cap.
●Add the specified engine oil until the engine oil
level is in the operating range on the dipstick.
NOTICE
●Avoid overfilling the engine with engine oil.
12.If the engine oil exceeds the upper mark level on
the dipstick:
• Drain the engine oil to a proper level.
13.Insert the dipstick to check the engine oil level.
14.Lower the hood.
■ Inspect the Transmission Hydraulic Oil
Level
1. Park the tractor safely and securely.
• For details, see "7. Safe Practices for Parking the
Tractor" on page 1-7.
2. Shut off the engine.
3. Chock all the tires safely and securely.
4. Allow the engine to cool down for several
minutes.
IMPORTANT
●Before removing transmission hydraulic oil filler
cap, carefully clean the area around the
transmission hydraulic oil filler cap.
●The preceding action prevents dirt and other
contaminants from entering the transmission.
●Avoid overfilling the transmission with
transmission hydraulic oil.
5. Read the transmission hydraulic oil gauge
window on the rear side of the transmission case.
• The transmission hydraulic oil level should be in
the middle of gauge window.
6. When the transmission hydraulic oil level is on the
lower mark:
• Clean the area around the transmission hydraulic
oil filler cap.
• Remove the transmission hydraulic oil filler cap
from the transmission housing.
• Add transmission hydraulic oil to the appropriate
transmission hydraulic oil level.
14. PERIODIC SERVICE
7. Install and tighten the transmission hydraulic oil
filler cap.
(A) Gauge window
(B) Transmission hydraulic oil filler cap
●How to view the gauge window
Too much
14-5
(A)
(A) (B)
Standard level
SA221/324/424 Operation Manual
(B)
(C)
Insufficient