Do you have a question about the YM155d and is the answer not in the manual?
Questions and answers
Kelly Reppert
March 5, 2025
Is a general-purpose tractor hydraulic fluid ok for a Yanmar155D tractor? if not please let me know what type I should use. Thank you.
John Gabri Jr
March 18, 2025
Where do I find the oil input for the rear lift, as per tiller???
Ken Prasad
April 1, 2025
how to align clutch shaft
1 comments:
Mr. Anderson
April 1, 2025
To align the clutch shaft on a Yanmar YM155D:
1. Set the No. 1 cylinder (flywheel side) to the Top Dead Center (TDC) position on the compression stroke by aligning the stamped mark on the crankshaft pulley with the indicator on the gear case. 2. Attach the clutch cover to the flywheel face and tighten it properly. 3. Measure the height from the flywheel face to the tip of the release lever using calipers and a scale. 4. Adjust the clearance after setting the total clutch pedal stroke and clutch pedal play.
These steps ensure proper alignment and function of the clutch shaft.
Need help?
Do you have a question about the YM155d and is the answer not in the manual?
Questions and answers
Is a general-purpose tractor hydraulic fluid ok for a Yanmar155D tractor? if not please let me know what type I should use. Thank you.
Where do I find the oil input for the rear lift, as per tiller???
how to align clutch shaft
To align the clutch shaft on a Yanmar YM155D:
1. Set the No. 1 cylinder (flywheel side) to the Top Dead Center (TDC) position on the compression stroke by aligning the stamped mark on the crankshaft pulley with the indicator on the gear case.
2. Attach the clutch cover to the flywheel face and tighten it properly.
3. Measure the height from the flywheel face to the tip of the release lever using calipers and a scale.
4. Adjust the clearance after setting the total clutch pedal stroke and clutch pedal play.
These steps ensure proper alignment and function of the clutch shaft.
This answer is automatically generated