Configure Management Port (Cm) - Thales payShield 10K Installation And User Manual

Configure Management Port (CM)

Command: CM
Function: To configure the Management port, which is an Ethernet port used only for
management of the HSM. If connection to the host is via Ethernet then the
Ethernet host port is used for that purpose. The Management Ethernet port is
used to update the HSM's internal software, updating licensing information,
and for enabling management of a HSM via the payShield Manager.
The new settings come into effect a few seconds after the command has
completed.
It is recommended that the Host Ethernet Ports, the Management Ethernet
Port, and the Auxiliary Ethernet Port are all on different IP subnets from each
other.
Authorization: The HSM must be in the offline or secure state to run this command.
• Whether IP address is manually or automatically derived.
Inputs:
• Ethernet speed setting.
• Enable (local or remote) payShield Manager connection?
Outputs: None.
Errors: None.
Example 1: In this example, the management port has its IP address set up manually.
Offline> CM
Management Ethernet Interface:
IP Configuration Method? [D]HCP or [S]tatic (DHCP): S
<Return>
Enter IP address (192.168.100.200): 192.168.200.90
<Return>
Enter subnet mask (255.255.255.0):
Enter Default Gateway Address (192.168.200.1):
Enter speed setting for this port:
0
1
2
3
4
5
6
Speed setting (4): 6
Enable payShield Manager connection:
Enable or Disabled? (E): D
Changing the IP address, Network name, or method requires
©Thales Group
All Rights Reserved
payShield 10K Installation and User Guide
o If manually derived, then the address details must be entered.
o If using DHCP, then a network name may be entered.
<Return>
SPEED OPTIONS:
Autoselect
10BaseT half-duplex
10BaseT full-duplex
100BaseTX half-duplex
100BaseTX full-duplex
1000BaseT half-duplex
1000BaseT full-duplex
Variant 
Online  Offline 
Authorization: Not required
<Return>
<Return>
<Return>
Key Block 
Secure 
<Return>
Page 253