Verizon 4G LTE Network Extender 3 for Enterprise Quick Start Manual

4G LTE Network Extender 3
for Enterprise
Connect to Connect to
GPS Antenna
GPS Antenna
GPS INT/EXT
GPS INT/EXT

Instructions

1 Connect the GPS antenna cable to the GPS port.
2 Position the GPS antenna puck near a window
so it provides a clear and open view of the sky.
3 Connect the Ethernet cable to the PoE/WAN
port and connect the other end of the cable
to the local router/switch.
4 If there is a Firewall in the network, please ensure
the following server connections are available to
the eFemto. The servers' FQDN/IP addresses can
be found in the Network Extender User Guide.
GPS Assistance Server: TCP port 80
DNS Server: UDP port 53
NTP Server: UDP port 123
Security Gateway: UDP port 500/4500
CMP: TCP port 80
5 Plug in the power supply to the Power port and twist to
lock (for installations where PoE is not supported).
.
6 OPTIONAL STEP - For local configuration,
connect a laptop to the LMT port to access
the Web GUI. For detailed instructions refer to
"Admin website access" in the Network Extender
User Guide.
7 Mount the Network Extender to a wall or ceiling.
Please wait up to 30 minutes for the unit to
complete setup and the Status LEDs to turn
GREEN indicating normal operation.
Visit verizon.com/support/4g-lte-network-extender-enterprise-basics/
or scan the QR code for detailed instructions and device information.
Connect to Connect to
Web GUI
Web GUI
Reset 1PPS
Reset 1PPS
For more information about our privacy
practices, visit verizon.com/about/privacy/
Customer Support: 800-922-0204
DOC-3197-01
Rev 1.0
Connect Connect to Connect to Connect to
Power Cord
Router
Power Cord
to Router
LMT PoE/WAN Power
LMT PoE/WAN Power