Table of Contents
Advertisement
Caused by: Short circuit detected in controller, motor cables, motor, or failed solenoid
B
A
2. Disconnect all three motor wires.
Contact the V wire lug to the pos. meter
terminal. Contact the U lug to the
negative terminal. Meter ohm resistance
should be 0.0 – 0.2. If not, replace motor.
A
B
4. Contact the U wire lug to the pos.
meter terminal. Contact the W lug to the
negative terminal. Meter ohm resistance
should be 0.0 – 0.2. If not, replace motor.
Customer Care
9024 AC Short Circuit
Page 10
A
B
3. Contact the V wire lug to the pos.
meter terminal. Contact the W lug to the
negative terminal. Meter ohm resistance
should be 0.0 – 0.2. If not, replace motor.
5. Try a known good controller if error is
gone, warranty controller. Error remains,
reinstall controller and contact Customer Care.
1. Turn key off and back on
to reset the controller. If car
runs, return to service. If
not, proceed to remaining
steps.
.
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the Ezgo RXV-E and is the answer not in the manual?
Questions and answers
I have a 2012 2Five and upgraded the batteries to lithium now w m getting the 25104 code. I replaced the key switch selector? Wonder if it a amp issue?
The 25104 code in the Textron Ezgo RXV-E corresponds to a "Direction Error." This means the vehicle's controller has detected an issue with the direction selection, such as conflicting inputs or a wiring fault. After upgrading to lithium batteries, ensure the wiring and control signals are correctly connected and the controller is properly configured for the new battery type.
This answer is automatically generated
@Mr. Anderson
The 2Five came with a 235amp controller and reading that I might need to up grade to a 350amp controller?