Table of Contents
Advertisement
Maintenance
(always first discharge the water and wait for the unit to cool down)
Lit
Dechlorination
Reboil
Long Boil
Temp.
Timer
60 85 98
Simultaneous flashing
Dechlorination
Reboil
Long Boil
Temp.
Timer
Buzzer sound
The citric acid is available from an authorized dealer.
( Model No:SAN-80N )
* Follow the directions for cleaning printed on the citric acid container.
* Since the citric acid used for cleaning is a food additive, it is harmless to humans.
Caution:
Do not clean with citric acid while the charcoal filter is installed.
¥
(The citric acid will dissolve the coral sand to smaller particles and the water will become cloudy.)
If cleaning with citric acid has been done: Replace the charcoal filter. (
¥ To remove any discoloration from the area above the full pot mark, rub the inside lightly with a wet sponge.
¥ If the discoloration cannot be removed by rubbing, clean the pot several times using citric acid.
26
All manuals and user guides at all-guides.com
Wash with citric acid (about once every 2 or 3 months).
1. Always first remove the charcoal filter.
2. Make sure that the filter is attached to the container.
3. Put citric acid in the container.
4. Add water to the full pot mark, and mix the citric acid and water well.
5. Mix well, close the lid, immediately connect the
plug, press
Cleaning start
The liquid crystal display will rotate and indicate cleaning.
Cleaning
h
Cleaning completion
Cleaning completion is announced by the buzzer and by
indication.
6. Remove the power cord and the lid, and drain the
hot water until you can see the drain mark.
7. Boil a fresh pot of water as usual, to remove any
residual smell of citric acid. Then, discard the water.
Cleaning
¥ After completion of the cleaning, install the charcoal filter.
h
When incrustations have formed
, and set
Select
¥ Cleaning time
About 50 minutes
P. 32)
to "Cleaning".
Advertisement
Table of Contents
