Poole Lighting 8403P Installation Instructions

Snape Solar PIR Outdoor Wall Light
Thank you for purchasing this Snape light fitting. Please read the instructions carefully before use to ensure safe
and satisfactory operation of this product.
Please keep these instructions for future reference
PIR Operating distance: 5-10m
PIR Operating angle: 120 o
Charging time: ~6 hours, based on 1000W/m 3
Operating hours: 6-10 hours
Output: 3.2V 1180mA 4W, 450lm
Battery (supplied): 1 x Li-ion battery 3.7V 2200mAh
Recommended installation height: 3.5m
Do not recharge non-rechargeable batteries.
Do not mix old and new batteries.
Do not mix batteries of different types.
Always insert the batteries with the correct polarity.
Always remove exhausted batteries from the product.
Do not short circuit the supply terminals.
Do not use rechargeable batteries
This product is suitable for use by adults only.

Fixing Instructions

Make sure you have the following items which are required to install this light fitting:
Small electrical screwdriver, cross head screwdriver & insulation tape.

Step 1

Using the wall back as a template mark the position of the fixing holes. Drill holes and fit supplied wall plugs
(suitable for masonry only - for other surfaces use appropriate fixings). Fit the screws into the holes so they are
protruding slightly.

Step 2

See Diagram 1 below. There are two key-shaped holes in the back of the product (see 'wall back' in Diagram 1).
Place the holes over the screws to hook the product in place. Ensure PIR sensor is facing downwards. If fitting is
loose, remove fitting from screws and retighten fixings accordingly.
Installation Instructions

Specification

Battery Care Warnings

Diagram 1
Wall Back
8403P