Poole Lighting Mirage Installation Instructions

This lighting system has been designed and manufactured exclusively for B&Q.
These instructions on wiring and installation are provided as a guideline to assist you. Some experience of electrical
wiring and do-it-yourself is required to install the light fitting. If at any time you are unsure of how to proceed, please
consult a qualified electrician.
The plug must be situated indoors (e.g. house, garage, shed) in order to protect it from the elements. During use these
products get hot Always switch off and allow product to cool before touching.

Before Starting

Please read through these instructions before commencing work, and keep them for future reference.
Please Take Extreme Care When Carrying Out These Instructions

This Kit contains:

1x 12V outdoor transformer with 2 metres of cable, 1 x 12 metre extension cable, 4 x spike fixings, 4 x outdoor lights,
4 x Mr16 20w 12v Halogen bulbs.

Information:

This lighting kit is designed for outdoors installation in the garden. This system operates at Safety Extra Low
Voltage (12V), via the outdoor transformer. Never connect the light fittings directly to the mains without using this
transformer.
Always remove the plug from the mains socket when installing or maintaining this system.

Layout:

Plan the desired position for these fittings
carefully, ensuring the cables will reach
the distances between the indoor plug, the
outdoor transformer and each light fitting.
Avoid locating any cables in positions that
would cause a trip hazard. Position cables
and transformer away from areas where they
may be at risk from being cut, trapped or
damaged.
The plug has no special protection against
moisture and must be situated indoors.
The 12 Volt transformer is rated at IP44 and
can be positioned outdoors. Avoid positioning
in very wet areas.
The light units are rated at IP44.
Do not bury the transformer in the ground
and avoid positioning it in very wet areas.

Installation:

1) Position the plug next to the indoor mains outlet socket that the system will connect to. Do not plug in at this
stage.
2) After deciding where to place the light fittings, and the position of the transformer, ensure the cables are long enough
to connect to the desired positions.
3) The transformer can be situated indoors or outdoors.
4) Lay out the 12 metre extension cable in the desired route, ensuring the cable does not present a trip hazard and
decide where to position each light along the cable.
5) Fit the ground spike to each light unit by pushing into position. Push each unit into the ground making sure the cable
attached will reach the extension cable.
6) Fit the bulbs as detailed overleaf.
7) Remove the top cover from the connection box by undoing the fixing screw. (see overleaf) Carefully remove the top
rubber seal.
Mirage Spike lighting set
Installation Instructions
Important!
2m Cable
IP44 rated outdoor 12V transformer
12m Cable
25cm Cable
IP44 rated x 4
halogen lights
4 x Spikes
Indoor plug
7438