NEC SigmaBlade N8406-026 User Manual page 54

(English)
Installing and Removing XFP Module
The following is described how to install and remove N8406-027 10GbE XFP Module in and from N8406-026 10Gb
Intelligent L3 Switch.
IMPORTANT:
・
Attach the dust covers to all vacant LC connectors to protect them
from contamination, if you store or transport the Switch Module
which the XFP modules are installed.
・
Optical power and sensitivity may be lower and cause malfunction
by coming into contact with contamination.
・
Install the XFP module to the XFP module slot straight. Do not force
to install it to avoid damage the module.
Avoid direct look into the laser beam.
The N8406-027 10GbE XFP Module is classified as a Class 1 Laser Product. A class 1
laser will not be harmful to the human body. However, do not look directly into the XFP
module port during operation. Keep any vacant LC connector covered with a dust cover
(rubber cap) when you do not use it or you transport it.
Installing XFP Module
1 Remove the dust cover attached to the XFP module.
2 Insert the XFP module to the XFP
module slot in the Switch Module.
NOTE: Insert the XFP module to the XFP module slot without pulling
down the lever. If you insert with the lever pulled down, a communication
failure may occur.
32
WARNING
N8406-026
XFP module
XFP Module
Dust cover
XFP module slot