First Time Instrument Setup; Connect The Instrument To The Internet - Thermo Scientific CTS Xenon User Manual

First time instrument setup

1. Place the instrument in a protected location with at least 10 cm of free space around the perimeter
for ventilation.
2. Connect the power supply cable to the power inlet.
The instrument operates at voltages of 100–240 VAC and the frequency range of 50/60 Hz. Ensure
that the local supply voltage in the laboratory conforms to that specified on the type label on the
back of the instrument

Connect the instrument to the Internet

The instrument can connect to the Internet by either wired or wireless methods.
To connect by wired method through the instrument Ethernet port using a cable, see "Set up a wired
connection" on page
To connect by wireless method through the instrument USB wireless adapter port with a USB-enabled
Wi-Fi card, see "Set up a wireless connection"
Set up a wireless connection
Connect the High-Power USB Wi-Fi Module (Cat. No.
page 8 for port location).
1. See "Set up a wired connection"
configuration screen.
2. In the Network configuration screen, select a field in the Wireless panel.
1
Wireless panel
1
Wired panel
2
Note: During initial setup, if you selected the Wired option in the Network Connection screen,
you will be required to enter the IP address if you selected the Static IP wired option. If you
selected the Dynamic IP wired option, the IP address is automatically populated.
CTS ™ Xenon ™ Electroporation System User Guide
19.
on page 19
2
on page 17.
A26774 to the USB wireless adapter port (see
Steps 1 through 3 to find the Network
Chapter 1 Product information
First time instrument setup
1
17