Specifications; Power Requirement - National Instruments SCC-AO10 User Manual

Specifications

Electrical

Power Requirement

SCC-AO10 Isolated Analog Output Module User Guide
Adjust the gain potentiometer on the top of the SCC-AO10 until the
voltmeter reads 9.9 VDC. The gain is now calibrated.
These ratings are typical at 25 °C unless otherwise stated.
Number of output channels.....................One nonreferenced (floating)
Input range ..............................................±10 V
Output range ...........................................±10 V
Current drive...........................................±30 mA
Gain nonlinearity ....................................0.5% of full-scale output range
Output noise............................................2.5 mV
Bandwidth...............................................>23 kHz
Slew rate .................................................1 V/µs
Short circuit protection
Current.............................................37 mA max
Duration...........................................Unlimited
Load impedance......................................10,000 pF max
Analog power .........................................180 mW max at full load
+15 V ...............................................6 mA max at full load
–15 V ...............................................6 mA max at full load
Digital power (+5 V) ..............................1.15 W max at full load
+5 V .................................................230 mA max
172 mW max with no load
5.73 mA max with no load
5.73 mA max with no load
600 mW max with no load
120 mA max with no load
8
typ; 4 mV max
rms rms
ni.com