Table of Contents
Advertisement
After the data transfer, the files will appear in the related browser.
NOTE:
O
"S
IF IN THE
PTION MENU
ET DOUBLE CLICK FUNCTION
To show the content of a file, it is enough to select it and click on the View button
detail of the performed memorization.
NOTE:
O
"S
IF IN THE
PTION MENU
ET DOUBLE CLICK FUNCTION
NOTE: N
OW IT IS POSSIBLE TO USE THE LINEARIZATION FROM
8.2
CalpMan 2007: Off-Line procedures
Standard Agencies and Quality Auditors require the collection, organization and analysis of traceability documents. CalpMan 2007 is able to transfer a selection of calibration routines
from a PC to the internal memory of the instrument in order to simplify field calibrations selecting the suitable tag number.
When a plant has a large number of process instruments, checks and field calibrations are really important in order to keep the compliance with ISO 9001 requirements.
MicroCal with CalpMan 2007 can be used as a traditional calibrator in order to check an instrument under test. In this case, we conventionally speak of procedure on-line, as the
connection between calibrator, instrument and PC is still active. For the definition of the procedure and about the software, see the CalpMan 2007 manual.
Instruction Manual MM850432 ed. 05c
The figure shows the Explorer window after a connection
The window is a complete image of the content of the memory of instrument and PC.
In the upper side, you can see the browser for linearization files into MicroCal memory.
In the lower side is instead shown a browser for PC files. Because of choosing LinMan, the PC browser is
automatically opened at "Linearization files" folder.
NOTE:
E
EVEN FROM
XPLORER WINDOW IT IS POSSIBLE TO SET THE PARAMETERS FOR THE SERIAL PORT BY MEANS OF
S
ETTINGS BUTTON
To transfer files from the instrument to PC or vice versa, you have to select them (one or more at the same
time) and press the button which defines the direction for data transfer to PC
"
"T
",
IS SET AS
RANSFER SELECTED FILES
. After a brief wait, due to data transfer, a window for the visualization is opened with the
"
"L
IS SET AS
AUNCH ASSOCIATED APPLICATION
"M
",
.
ATH FUNCTION
AS SEEN ABOVE
86
(
THESE SETTINGS WILL BE JUST TEMPORARY
FOR DATA TRANSFER IT IS ENOUGH A SIMPLE DOUBLE CLICK
",
TO SHOW THE FILE IT IS ENOUGH A SIMPLE DOUBLE CLICK
)
or to the instrument
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the MicroCal 20 Series and is the answer not in the manual?
Questions and answers