Table of Contents
Advertisement
6.
CAN bus baud rate. Press set button to apply changes. Baud rate can be set to:
7.
CAN bus mode: Standard or Extend mode. Press set button to apply change.
8.
Enable or disable RTR mode. Press set button to apply change.
If RTR is enabled, a remote frame will be transmitted via the bus. This means that no
data bytes are included within this frame. It is necessary to specify the correct data
length code which depends on the corresponding data frame with the same identifier
coding. If the RTR is not enabled, a data frame will be sent including the number of
data bytes as specified by the data length code.
9.
CAN bus ID: The identifier is transmitted on the bus first during the arbitration
process. The identifier acts as the message name.
10.
Data Field: Data to be transmitted.
11.
Received data will be listed here
12.
Send button, send the data set in Data Field
13.
Loop Test function: Sends data automatically.
14.
Receive button: Press to start receiving data.
15.
Clear receive field
16.
Mask and Filter; opens Mask and Filter menu (detailed on next page).
17.
Get status from firmware register
18.
Get error status from firmware register
19.
Load Default settings
20.
Save current settings to firmware register
Chapter 5 – SDK Guide
Mode
ID Range
Standard Mode
Extend Mode
125K
500K
1M
0x000~0x7FF
0x00000000~0x1FFFFFFF
83
Advertisement
Table of Contents
