Sealey VS819900 Instructions

Thank you for purchasing a Sealey Product. Manufactured to a high standard this product will, if used according to these instructions and
properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS,
WARNINGS AND CAUTIONS. USE THIS PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS
INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR PERSONAL INJURY AND WILL INVALIDATE THE
WARRANTY. PLEASE KEEP INSTRUCTIONS SAFE FOR FUTURE USE.
1. SAFETY INSTRUCTIONS
 WARNING! Ensure Health and Safety, local authority and general workshop practice regulations are adhered
to when using the bore scope.
 Maintain the bore scope in a good and clean condition for best and safest performance.
 Ensure that a vehicle which has been jacked up is adequately supported with axle stands.
 A full range of personal safety equipment is available from your Sealey dealer.
 Wear suitable clothing to avoid snagging. Do not wear jewellery and tie back long hair.
 Account for all tools and parts being used and do not leave any in, or near, the engine.
 Be alert to your surrounding environment while using the bore scope.
 DO NOT use the bore scope if it is damaged.
 DO NOT point the Distal Tip towards the sun or any bright light source, as permanent eye damage may
occur.
 DO NOT bend the bore scope shaft tighter than a 76mm radius.
 DO NOT use the bore scope close to moving parts such as gears, fan blades or moving belts.
 DO NOT expose the bore scope housing to water or other liquids.
 DO NOT insert the bore scope shaft into locations where the temperature is likely to be greater than 70°C.
2. INTRODUCTION
Suitable for internal inspection of cylinder bores, engine components and other machinery/industrial applications.
Flexible shaft can be bent to shape to fit through small apertures and around obstacles. Subject illumination is
provided by two LEDs which are controlled by a three-position switch, giving low output, full output and off. LEDs
are powered by 4 x AA batteries (supplied). Adjustable eyepiece allows user to tailor optics to suit their vision.
Supplied in carry-case.
3. SPECIFICATION
Shaft Length: . . . . . . . . . . . . . . . . . . . . . . 900mm
Probe Diameter: . . . . . . . . . . . . . . . . . . . . . 10mm
INSTRUCTIONS FOR:
BORE SCOPE
VS819900
MODEL NO:
Batteries (supplied): . . . . . . . . . . . . . . . . . . 4 x AA
Fig 1
VS819900 Issue: 1 - 14/10/08