To Re-Configure The Auto Transformer - inTest THERMOSTREAM ATS-545 Interface & Applications Manual

P R E P A R A T I O N F O R U S E
2

To Re-Configure the Auto Transformer

To Re-Configure the Auto Transformer
Re-Configure the
Transformer
2-20
Electrical Hazard
Only qualified service personnel familiar with the electrical shock hazards present inside the
equipment should perform any disassembly or corrective maintenance.
Step
1 Power down the System and disconnect the Main Power cord and Main Air
Supply.
2 Remove the right side panel.
To remove the panel:
1. Unscrew the four quarter-turn locking screws.
2. Gently pull the panel outward several inches, without damaging the ground
wire (which is attached to the panel).
3. Detach the protective ground wire; be careful to reconnect the ground wire
upon re-assembly.
3 Locate the High Voltage rail and Voltage Configuration Card:
Voltage
Configuration
Card
High Voltage
Rail
ATS-545 & -645 Interface & Applications Manual
Action