Demo Mode; To Recover The Pin Code - Husqvarna Automower 550 Workshop Manual

There are 3 options when programming a new
application circuit board:
• Select product from the Log book
Select product from the Log book and the serial
number and operating data is transferred
automatically to the new application circuit board.
This requires that the product previously has been
connected to Autocheck.
• Enter the serial number manually in Autocheck
If the product never was connected to Autocheck,
the serial number must be entered manually in the
Actions - Unit replacement menu. It is then very
important to enter the correct serial number.
• Use service mode
If the application circuit board is replaced when
troubleshooting, and you are not sure if the
application circuit board will be kept in the product, it
is possible to temporarily skip to enter the serial
number and use the application circuit board in
Service mode. When the product is in Service mode,
Service mode flashes in the display. Only
the text
Autocheck can be used to control the product in
Service mode.
WARNING: Do not return the product to the
customer in Service mode.

5.7 Demo mode

Demo mode is used for installations outside shops or
exhibitions. The product alternates between short
periods of operation, docking and charging. Demo mode
can be enabled and disabled in Autocheck.
WARNING: Do not have the blades installed
when the product operates for demonstration in
public areas such as shops and exhibitions.

5.8 To recover the PIN code

If the customer has a registered e-mail address in the
®
Automower Connect app, there is a link to get the PIN
code by e-mail. If the customer does not have a
registered e-mail address, the PIN code can be retrieved
via Autocheck and local sales support.
1. In Autocheck, select
settings - Get security code to upload the security
code to the cloud.
2. Speak to the local sales support and tell them the
serial number. They can identify the correct PIN
code.
1541 - 001 -
Actions - Advanced mower
Autocheck service tool - 11