Lifting Hook 60 - Meva Mammut XT Technical Instruction Manual

Wall Formwork

Lifting hook 60

The lifting hook (Fig. 81.1) can
be used with any 4-rope crane
sling on the construction site to
transport panel stacks (Fig. 81.2).
Always use four hooks at once.
To calculate the permissible load-
bearing capacity, assume that
only two hooks are used.
Attention
A lifting hook must only be
used if its eccentric is easy to
turn or falls automatically into
the locked position (Fig. 81.4).
Never use a lifting hook if you
need force to turn its eccentric.
Turning the eccentric with force
may not lock the lifting hook but
only make it appear to be in the
locked position. This may cause
the lifting hook to slip out when
lifting the panel stack.
Technical data
Æ Weight 2.0 kg per lifting
hook
Æ Max. load 10 kN (1 ton) per
lifting hook
Æ Max. load 20 kN (2 tons)
per panel stack
Æ Max. stack height: three
Mammut XT panels
350/250 or ten Mammut XT
panels with a maximum
width of 125 cm.
Moving panel stacks
When moving panel stacks,
make sure the panels are secured
against sliding
(see page XT-83).
Description Ref. No.
Lifting hook 60 ...................... 29-401-40
Technical Instruction Manual / Status August 2021
Lifting hook
Fig. 81.1
Lifting hook
Fig. 81.3
Fig. 81.4
Fig. 81.2
Eccentric in locked position
Mammut XT
XT-81