Chapter 2 Connecting The Scansnap; Installing The Supplied Software - Fujitsu ScanSnap S300M Getting Started Manual

Chapter 2 Connecting the ScanSnap

This chapter describes how to connect the ScanSnap to your computer.

2.1 Installing the Supplied Software

Before connecting the ScanSnap to your computer, install the following software on your
computer.
Software
ScanSnap Manager
(Driver)
Cardiris
( : Supported, –: Not supported)
*1) When the operating system you are using is Mac OS X v10.2.8.
*2) When the operating system you are using is Mac OS X v10.3.9.
ATTENTION
■ Installing Cardiris
Prepare the Cardiris CD-ROM.
1. Insert the "Cardiris™ Setup CD-ROM" into the CD-ROM drive.
2. Double-click the "Cardiris 3.6 for ScanSnap" on the desktop.
3. Double-click the "Cardiris 3.6 for ScanSnap" icon.
⇒ A screen of Cardiris installation appears.
15
Mac OS X Mac OS X
v10.1 v10.2 (*1)
–
–
• We recommend applying the latest updates to the Mac OS for better
reliability.
• Log on as a user with Administrator privileges.
• Requirements for the ScanSnap S300M are as follows:
CPU: - PowerPC
- Intel
(Intel
recommended)
Memory: 128MB or more
(512MB or more is recommended. When the OS is
Mac OS X v10.5, 1GB or more is recommended.)
* If the CPU and memory do not meet the recommended requirements
or the USB version 1.1 is used, the scanning speed will slow down.
Mac OS X
v10.3
–
(*2)
®
G4 Processor 800MHz or higher
®
Core™ Solo or Duo Processor
®
Core™ Duo Processor 1.83GHz or higher is
Mac OS X Mac OS X
v10.4 v10.5