List Of Messages - Canon XH A1 Instruction Manual

List of Messages

Message
SET THE TIME ZONE, DATE
AND TIME
CHANGE THE BATTERY
PACK
THE TAPE IS SET FOR
ERASURE PREVENTION
REMOVE THE CASSETTE
CHECK THE HDV/DV INPUT
CONDENSATION HAS BEEN
DETECTED
TAPE END
HEADS DIRTY, USE
CLEANING CASSETTE
NO CARD
NO IMAGES
CARD ERROR
CARD FULL
NAMING ERROR
UNIDENTIFIABLE IMAGE
THE CARD IS SET FOR
ERASURE PREVENTION
INCORRECT TAPE
SPECIFICATION PLAYBACK
IS RESTRICTED
INPUT SIGNAL NOT
SUPPORTED
PLAYBACK STD LOCKED
PLAYBACK IS RESTRICTED
PLAYBACK STD LOCKED
INCOMPATIBLE VIDEO INPUT
COPYRIGHT PROTECTED
PLAYBACK IS RESTRICTED
COPYRIGHT PROTECTED
DUBBING RESTRICTED
You have not set the time zone, date and time. This message appears each
time you turn the power on until you set the time zone, date and time.
Battery pack is exhausted. Replace or charge the battery pack.
Cassette is protected. Replace the cassette or change the position of the
protect switch.
Camcorder stopped operating to protect the tape. Remove the cassette and
reinsert it.
DV cable is not connected, or the connected digital device is turned off.
Condensation has been detected in the camcorder.
Tape reached the end. Rewind the tape or replace the cassette.
Video heads are dirty. Clean the video heads.
Memory card not is inserted into the camcorder.
No images are recorded on the memory card.
A memory card error occurred. The camcorder cannot record or play back the
image.
The error may be temporary. If the message disappears after 4 seconds an
" " flashes red, turn the camcorder off, remove the card and reinsert the
card. If " " changes to green, you can continue recording/playback.
No remaining capacity on the memory card. Replace with another card or
erase images.
The folder and file numbers have reached their maximum value.
Image is not recorded with JPEG compression, or with a compression not
compatible with the camcorder, or the image file is corrupted.
SD/SDHC memory card is set for erasure prevention. Replace the card or
change the position of the protect switch.
You attempted to play back a tape recorded in a standard different than the one
to which is the camcorder is set.
You attempted to input a video signal incompatible with the camcorder (for
example 720p).
When the playback standard is already set in the camcorder, you attempted to
play back a tape in a video standard different from that set.
When the playback standard is already set in the camcorder, you attempted to
input a video signal in a standard different from that set.
You attempted to play back a copyright protected tape.
You attempted to dub a copyright protected tape. May also appear when an
anomalous signal is received during analog line-in recording, or during analog-
digital conversion of a copyright protected tape.
Explanation
E
26
15
150
23
106
148
–
147
24
–
–
–
–
–
24
–
106
95
106
107
107
145