Sharp 2T-C45AE1X Service Manual page 15

[4] PUBLIC MODE SETTING PROCEDURE
[1] How to start Public Mode.
There are the following 3 ways to get the public mode setup screen displayed.
1) Start up from body key
During SPECIAL SERVICE KEY MODE,
a) All RC key is blocked during this period.
b) LED blinking RED -> GREEN -> RED -> GREEN.
Function list menu displayed
Single press Scroll selection from top
Hold pressed Select selected item
c) Backlight turned On, screen display show Purple test pattern. With function list menu displayed. First item highlighted
Inspec on 2
PIN input mode
Clear password
Public mode
Service mode
d) After run function, Special Service Key mode is ended and LED -> GREEN.
2) Start up from Service remote to display Service Mode.
a) To display Service mode, required by using Servie remote.
b) When Service mode display, change the page to the next page.
c) Then select Public Mode and switch it to ON state.
d) Swithc the set by pushing ON/OFF button or by plugged off the supply.
Start up from body key to display Public Mode.
During SPECIAL SERVICE KEY MODE (same as Start
a) All RC key is blocked during this period.
b) By press One Push Button simultaneously with switch On the AC Cord.
c) LED blinking GREEN repeatedly. Then press and release Single Push Button twice and
for the third time press and hold Single Push Button untill LED stop blinking and panel change to black with logo 'SHARP' display.
d) Backlight turned On, screen display show Purple test pattern. With function list menu displayed. First item highlighted and
by push Single press repeated to scroll down untill at Public Mode column. Then Hold pressed to display.
3) Start up from remote control key.
a) During POWER-ON state, if you push [Public-MODE] key of the remote controller, TV will display PublicSetting MENU.
up from b ody key meth od)
5 – 8
R: 128, G:128, B:255 (Or similar color)
Highlight will move to up when it come to the end
2T-C45AE1X