Table of Contents
Advertisement
Chapter 2 Preparations
1.13.2 Removal
(1)
2.5-inch HDD cage
The server can contain up to three 2.5-inch HDD cages. Remove cages starting from the bottom bay.
Remove 2.5-inch HDD cage in the following procedure.
1.
Refer to steps 1 to 7 in Chapter 2 (1.3 Overview of Installation and Removal) for preparations.
2.
Remove hard disk drives from 2.5-inch HDD cage.
3.
Disconnect SAS/SATA cable, SGPIO cable, and power cable.
4.
Remove screws that secure the 2.5-inch HDD cage.
5.
Pull out 2.5-inch HDD cage from the server.
6.
To use the server with 2.5-inch HDD cage removed, attach blank covers using screws.
(2)
3.5-inch HDD cage
The server can contain up to two 3.5-inch HDD cages. Remove cages starting from the bottom bay.
Remove 3.5-inch HDD cage in the following procedure.
1.
Refer to steps 1 to 7 in Chapter 2 (1.3 Overview of Installation and Removal) for preparations.
2.
Remove hard disk drives from 3.5-inch HDD cage.
3.
Disconnect SAS/SATA cable, SGPIO cable, and power cable.
4.
Remove screws that secure the 3.5-inch HDD cage.
5.
Pull out 3.5-inch HDD cage from the server.
6.
To use the server with 3.5-inch HDD cage removed, attach blank covers using screws.
7.
If you install another HDD cage, remove two guides.
Important
To maintain cooling effect in the server, be sure to attach blank covers.
Important
To maintain cooling effect in the server, be sure to attach blank covers.
Express5800/T120e User's Guide
1. Installing Internal Optional Devices
101
Advertisement
Table of Contents
