Table of Contents
Advertisement
6.3.
Procedure
No.
Display on the screen
0
8:88
1
05 or Turbidity value
2
04/Temperature value
3
03
4
02
5
01
6
F*
Procedure of Test Program (for models controlling water filling by flowmeter)
Process
Initialization
Power on, standby mode.
Open inlet valve and fill with 3.6L water. The diverter would move to position rotating
Inlet Valve
both upper and lower sprayarms. If the model is equipped with turbidity sensor,
turbidity value would be adjusted and shown on the screen.
Higher-speed
Run higher-speed washing pump and 10s later run heating element until water
Washing Pump
temperature reaches 57°C. Then the machine will pause.
and Heating Element
Press Start/Pause button to jump into the next step.
Lower-speed
Washing Pump
2s later run lower-speed washing pump for 8s. dispenser will act for 45s in this step.
and Dispenser
Regeneration Valve
Open regeneration valve for 30s.
Drain Pump
Drain for 30s.
finish
Buzz one sound, stop, and stand by.
Description
43
Advertisement
Table of Contents
Troubleshooting
