Maintenance And Repair; Cleaning And Care; Inspection; Maintenance - Bosch rexroth PE 2/X Assembly Instructions Manual

30/40

Maintenance and repair

Bosch Rexroth AG, MIT: PE 2/X, PE 2/H, PE 4, 3 842 564 350/2020-06
10 Maintenance and repair
High pneumatic pressure!
Risk of serious injury to eyes and body parts from whipping hoses and sudden
compressed air release.

Switch off the compressed air supply to the relevant system component before
performing any maintenance or repairs.

Ventilate the pneumatic circuit of the relevant system component.

Secure the system against being unintentionally switched on again.

Wear safety goggles.
• Only inspect and adjust continuous conveyors that are in motion or operation when
the safety guards are in place.
• Note DIN EN ISO 13857 when you remove or replace safety guards and/or bypass
safety equipment.
• Test runs with open paneling should only be performed by a person with
appropriate knowledge and experience using tip switches, and if there is no
possibility of interference from other switching devices.

10.1 Cleaning and care

Bearing and toothed belt failure

Keep degreasers and corrosive cleaning agents away from bearings and toothed
belts!

Only clean the product with a damp cloth.

10.2 Inspection

Lift unit
Regularly check the pneumatic connections for leaks.

10.3 Maintenance

Bearings
The bearings have lifelong lubrication and are maintenance-free under normal
operating conditions.
WARNING
NOTICE