Overheating Protection - Miele KM 7678 FR Operating And Installation Instructions

Safety features

Overheating protection

All the induction coils and heat sinks for
the electronic module are fitted with an
overheating protection mechanism. Be-
fore the induction coils or heat sinks get
too hot, the overheating protection
mechanism intervenes in one of the fol-
lowing ways:
Induction coils
- Any Booster function in operation will
be switched off.
- The set power level will be reduced.
- The heating switches off automatic-
ally.  will flash alternately
with  in the timer display.
You can use the zone again as usual
when the fault message has gone out.
Heat sink
- Any Booster function in operation will
be switched off.
- The set power level will be reduced.
- The heating switches off automatic-
ally.
The affected zones can only be used
again as usual once the heat sink has
cooled down to a safe level.
44
The overheating protection may be ac-
tivated under the following circum-
stances:
- The cookware being heated is empty.
- Fat or oil is being heated on a high
power level.
- There is insufficient ventilation to the
underside of the hob.
- A hot zone is switched on after an in-
terruption to the power supply.
If, despite removing the cause, the
overheating protection mechanism trig-
gers again, contact the Customer Ser-
vice Department.