Error Code Chart; Dryer Settings Chart - Frigidaire GLEQ2152EE0 Operating Instructions Manual

If the dryer stops, the status lights flash, the signal beeps and a code is displayed, an error has occured. Press PAUSE/CANCEL twice. Consult the Error Code Chart below or the
"Avoid Service Checklist" in the Owner's Guide for the possible cause and solution. Make necessary corrections, then select a cycle and press START. If the dryer stops, the status
lights flash again, the beeping continues and the code reappears, please contact service for assistance.
Error Code Error
Dryer ran too long
4 beeps / E4A
Push button does not function
6 beeps / E68
AVAILABLE CYCLE SETTINGS - These temperatures, dryness levels and options are available with the following cycles:
Estimated
drying time ***
Temperatures
High
Medium-High
Medium
Low
No Heat
Dryness Level
More Dry
Normal Dry
Less Dry
Damp Dry
Options
Shrink Guard
Press Saver
Cycle Signal
* Factory
setting

ERROR CODE CHART

Lint filter blocked. Ventilation system clogged. Dryer overloaded.
Push button held too long or wedged in the control panel.

DRYER SETTINGS CHART

Towels Normal Perm Press
60 minutes 50 minutes 40 minutes
*
*
*
** **
* * *
*
* * *
Available ** Not
settings recommended
Possible Causes
Delicate Quick
20 minutes 30 minutes
*
*
** **
*
*
*
* *
*** Estimated cycle duration is based on normal
dryness level and factory settings.
Solutions
Remove lint; wash lint filter to
remove softener sheet residue
Clean out ventilation system.
Reduce load size.
Press buttons lightly and release.
Disengage button.
Bulky Timed Dry
15 to 90
45 minutes
minutes
*
*
* *
PN 134431300C (0604)