Error Code Chart; Dryer Settings Chart - Frigidaire AEQ6000CES0 Operating Instructions Manual

If the dryer stops, the status lights flash, the signal beeps and a code is displayed, an error has occured. Press CANCEL. Consult the Error Code Chart below or the "Avoid Service
Checklist" in the Owner's Guide for the possible cause and solution. Make necessary corrections, then select a cycle and press START. If the dryer stops, the status lights flash
Error Code Error
4 beeps / E4A Dryer ran too long
9 beeps / E9E Line voltage problem
Push button does not function
6 beeps / E68
AVAILABLE CYCLE SETTINGS - These temperatures, dryness levels and options are available with the following cycles:
Estimated
Drying Time **
Temperatures
Maximum
High
Medium
Low
Air Fluff/No Heat
Dryness Level
More Dry
Normal Dry
Less Dry
Damp Dry
Options
Shrink Guard
Extended Tumble
Signal Volume
* Factory
setting

ERROR CODE CHART

again, the beeping continues and the code reappears, please contact service for assistance.
Lint filter blocked. Ventilation system clogged. Dryer overloaded.
Push button held too long or wedged in the control panel.

DRYER SETTINGS CHART

Towels Heavy Duty Normal
60 minutes 45 minutes 50 minutes
* * *
*
* *
* * *
Available
settings
Possible Causes
Low voltage. Intermittent voltage.
Perm Press Delicate
40 minutes 20 minutes
*
*
*
*
*
* *
* *
** Estimated cycle duration is based on normal
dryness level and factory settings.
Solutions
Remove lint; wash lint filter to
remove softener sheet residue
Clean out ventilation system.
Reduce load size.
Press Cancel.
Press buttons lightly and release.
Disengage button.
Touch Up Timed Dry
15 to 90
30 minutes
15
minutes
*
*
* *
PN 134598200 (0512)