Advertisement
Table of Contents
Event Tent
20ft x 20ft
™
20ft Wide x 20ft Deep x 6ft 9in Side Height /
12ft 4in Center Height
King Canopy Item #: ET2020G
With 8 Legs, Green & White PE Cover,
Elastic Ball Straps & Foot Pads.
WARNING:
Keep all flame and heat sources
away from this tent fabric. Meets
the flammability requirements of
Distributed by:
CPAI-84 & NFPA 701. It is not fire proof.
PIC America, LTD.
The fabric will burn if left in continuous
8009 Purfoy Road • Fuquay-Varina, NC 27526
contact with any flame source.
1-800-800-6296 • www.kingcanopy.com
Advertisement
Table of Contents
Related Manuals for KING CANOPY Event Tent 20ft x 20ft
Summary of Contents for KING CANOPY Event Tent 20ft x 20ft
- Page 1 20ft x 20ft ™ 20ft Wide x 20ft Deep x 6ft 9in Side Height / 12ft 4in Center Height King Canopy Item #: ET2020G With 8 Legs, Green & White PE Cover, Elastic Ball Straps & Foot Pads. WARNING: Keep all flame and heat sources away from this tent fabric.
-
Page 2: Parts List
PARTS LIST 6X6-2PC 16 pc 77.5” x 2” Pipe 6X6-15PC 9 pc 77.5” x 1 1/2” Pipe 4X2-2PC 8 pc 50” Swedge pipe 3W215PC 6 pc 3-way connectors 4W215PC 6 pc 4-way connectors BALLW 48 pc Elastic ball straps PFOOT2 8 pc Foot pads T2020ETG... -
Page 3: Frame Assembly
FRAME ASSEMBLY Step 1 Separate all pieces according to size and shape and arrange per the illustration shown below. Please note: • The 8 - 50” x 2” and 8 - 77.5” x 2” pipes are used to form the roof rafters •... -
Page 4: Cover Assembly
COVER ASSEMBLY Step 1 Unfold the cover with the grommets toward the cover’s bottom and place over the frame. The flared edges should be located at each of the 4 corners of the frame. Step 2 Begin attaching the cover with the elastic ball straps by inserting the elastic cord of the ball strap underneath the cover and through the grommet. - Page 5 LEGS ASSEMBLY NOW, CONNECT THE LEG POLES TO THE ROOF ASSEMBLY WITH THE COVER ALREADY POSITIONED ON TOP OF THE UNIT. Insert Second Insert First Step A: First insert the pipes for the middle poles into the 3- and 4-way connectors, and then connect the end leg pipes in the same way.
- Page 6 ANCHORING YOUR UNIT This canopy is designed for use as a temporary structure. After assembly, the canopy MUST BE securely an- chored to the ground to prevent damage from winds. Your canopy will act like a kite in the wind if not prop- erly and securely anchored to the ground.
- Page 7 IMPORTANT NOTICE: PLEASE READ CAREFULLY We are confident that you will be completely satisfied with your King Canopy unit. Please take a moment to read the very important information below, and call us with any questions you may have. King Canopy/PIC America, LTD. has no control over wind, snow, ice, rain or any other weather condition and we are in no way responsible for any damage caused by the canopy or to the canopy.
-
Page 8: Product Information
Improper Anchoring, Strong Winds, Rain, Snow, Ice NOT put away your Instant Canopy while wet or damp. This King Canopy/ PIC America, LTD. does not guarantee these promotes mildew. Store DRY. For best results in keeping your canopies under strong weather conditions (including snow top clean and avoiding small tears, it is recommended that &...
Need help?
Do you have a question about the Event Tent 20ft x 20ft and is the answer not in the manual?
Questions and answers