Yamaha Ego Avantiz Owner's Manual page 51

1
1. Engine oil drain bolt A
2. Engine oil drain bolt B
TIP
When only changing the engine oil, re-
move drain bolt A. When changing the
engine oil and cleaning the engine oil
strainer, remove drain bolt B also.
Periodic maintenance and adjustment
2
ZAUU0056
1. Oil strainer
2. Compression spring
3. O-ring
4. Clean the engine oil strainer with
solvent, and then check it for
damage and replace it if neces-
sary.
5. Install the engine oil strainer, com-
pression spring, engine oil drain
bolt with new O-ring, and then
tighten the drain bolt to the speci-
fied torque.
TIP
Make sure that the O-ring is properly
seated.
Tightening torque:
6. Refill with the specified amount of
Recommended engine oil:
Oil quantity:
TIP
Be sure to wipe off spilled oil on any
parts after the engine and exhaust sys-
tem have cooled down.
NOTICE
7-12
Engine oil drain bolt A:
20 Nm (2.0 m·kgf, 14 ft·lbf)
Engine oil drain bolt B:
20 Nm (2.0 m·kgf, 14 ft·lbf)
the recommended engine oil, and
then install and tighten the oil filler
cap.
See page 9-1.
0.80 L (0.85 US qt, 0.70 Imp.qt)
In order to prevent clutch slip-
page (since the engine oil also
lubricates the clutch), do not
mix any chemical additives. Do
not use oils with a diesel speci-
fication of "CD" or oils of a high-
er quality than specified. In
7
ECA11621