The call is entered on the selected channel and
scanning is halted until the call is exited by
pressing
below either page or call.
Deleting a Nuisance Channel
If a channel continually generates unwanted calls or
noise (termed a "nuisance" channel), you can
temporarily remove the unwanted channel from the
scan list.
This capability does not apply to priority channels or
the designated transmit channel.
When the radio is locked onto the channel to be
deleted,
Select button directly below Nuis.
The radio continues scanning the remaining channels
in the list.
Restoring a Nuisance Channel
To restore the deleted nuisance channel, perform
one of the following actions:
•
Stop and restart a scan.
70
English
or pressing the Menu Select button
or
to Nuis and press the Menu
•
Mode change to another channel and back to
the original channel.
•
Turn off the radio and then turn it on again.
Nuisance mode delete can be disabled by the
system administrator.
Changing Priorities Status While Scan is On
While the radio is scanning, the dynamic priority
change feature allows you to temporarily change any
channel in a scan list (except for the Priority-One
channel) to the Priority-Two channel.
This change remains in effect until scan is turned off.
Scan then reverts to the preprogrammed (original)
setting.
1 Press the Menu Select button directly below DYNP
to change the priority of a non-priority channel in
the scan list to Priority-Two.
2 Press
momentarily to exit the scan list and
resume scanning.
Restoring Priorities in a Scan List
To restore the original channel priorities in a scan
list, perform one of the following actions: