Wcdma Rx Chain Activation For Manual Measurement/Wcdma Rssi Measurement - Nokia 6500 SLIDE RM-240 Service Manual

RM-240
RF troubleshooting

WCDMA RX chain activation for manual measurement/WCDMA RSSI measurement

Prerequisites
Make the following settings in Phoenix service software and in the signal generator.
Phoenix channel
Signal generator to antenna connector
Steps
1. Via Phoenix Testing menu, choose WCDMA/RX Control.
2. In the RX control window, make the following settings:
3. Click Start to activate the settings.
If the settings are changed later on (for example, change of channel) you have to click Stop and Start
again.
Note: Clicking Stop also disables TX control if it was active.
4. From the Phoenix testing menu, select WCDMA→RX Power measurement
5. In the RX Power measurement window, select:
• Mode: RSSI
Issue 1
Setting
Figure 16 RX Control window with example settings
COMPANY CONFIDENTIAL
Copyright © 2007 Nokia. All rights reserved.
1637
2132.4 MHz
Band IV
Page 4 –13