Toro 74255 Operator's Manual page 35

With 60in turbo force side discharge mower
Hide thumbs Also See for 74255:
Table of Contents

Advertisement

2
1
m–4811
Figure 41
1. Oil dipstick
2. Filler tube
Changing the Oil
1. Start the engine and let it run five minutes. This warms
the oil so it drains better.
2. Park the machine so that the drain side is slightly
lower than the opposite side to assure the oil drains
completely.
1. Disengage the PTO, move the motion control levers to
the neutral locked position and set the parking brake.
2. Stop the engine, remove the key, and wait for all
moving parts to stop before leaving the operating
position.
3. Place a pan below the oil drain. Rotate the oil drain
valve to allow oil to drain (Fig. 42).
Figure 42
1. Oil drain valve
4. When the oil has drained completely, close the drain
valve.
Note: Dispose of the used oil at a certified recycling
center.
5. Slowly pour approximately 80% of the specified oil
into the filler cap (Fig. 41). Refer to Servicing the
Engine Oil, page 34.
3
m–3219
3. Metal end
1
m–5624
6. Check the oil level; refer to Checking the Oil Level,
page 34.
7. Slowly add additional oil to bring it to the full mark.
Change the Oil Filter
Replace the oil filter every 200 hours or every other oil
change.
Note: Change the oil filter more frequently when
operating conditions are extremely dusty or sandy.
1. Drain the oil from the engine; refer to
Changing/Draining Oil, page 35.
2. Remove the old filter and wipe the filter adapter
(Fig. 43) gasket surface.
3. Pour new oil of the proper type in through the center
hole. Stop pouring when the oil reaches the bottom of
the threads. Allow a minute or two for the oil to be
absorbed by filter material.
4. Apply a thin coat of new oil to the rubber gasket on
the replacement filter (Fig. 43).
1
Figure 43
1. Oil filter
2. Gasket
5. Install the replacement oil filter to the filter adapter.
Turn the oil filter clockwise until the rubber gasket
contacts the filter adapter, then tighten the filter an
additional 1/2 turn (Fig. 43).
6. Fill the crankcase with the proper type of new oil;
refer to Changing the Oil, page 35.
35
3
2
m–1256
3. Adapter

Advertisement

Table of Contents
loading

This manual is also suitable for:

Z588e z master

Table of Contents