Engine Oil And Oil Filter Cartridge - Yamaha 2005 MT-01 Owner's Manual

Engine oil and oil filter
cartridge
The engine oil level should be checked
before each ride. In addition, the oil
must be changed and the oil filter car-
tridge replaced at the intervals speci-
fied in the periodic maintenance and
lubrication chart.
To check the engine oil level
1. Place the vehicle on a level sur-
face and hold it in an upright posi-
tion.
NOTE:
Make sure that the vehicle is positioned
straight up when checking the oil level.
A slight tilt to the side can result in a
false reading.
2. Start the engine, warm it up until
the engine oil has reached a nor-
mal temperature of 60 °C (140 °F),
let it continue to idle for ten sec-
onds, and then turn the engine off.
PERIODIC MAINTENANCE AND MINOR REPAIR
EAU36802
NOTE:
To achieve the proper engine oil tem-
perature for an accurate oil level read-
ing, the engine must have first
completely cooled down, and then
warmed up again for several minutes to
normal operating temperature.
3. Wait a few minutes until the oil set-
tles, remove the oil filler cap, wipe
the dipstick clean, insert it back
into the oil filler hole (without
screwing it in), and then remove it
again to check the oil level.
1. Engine oil filler cap
NOTE:
The engine oil should be between the
minimum and maximum level marks.
1. Maximum level mark
2. Minimum level mark
3. Dipstick
4. If the engine oil is at or below the
NOTE:
When adding oil, be careful not to over-
fill the engine oil tank; the oil level rises
faster starting from the half level portion
on the dipstick.
5. Insert the dipstick into the oil filler
6-7
minimum level mark, add sufficient
oil of the recommended type to
raise it to the correct level.
hole, and then tighten the oil filler
cap.
6