Table of Contents
Advertisement
NOTE:
If the display indicates error code 52,
this could be caused by transponder in-
terference. If this error code appears,
try the following.
1. Use the code re-registering key to
start the engine.
NOTE:
Make sure there are no other immobi-
lizer keys close to the main switch, and
do not keep more than one immobilizer
key on the same key ring! Immobilizer
system keys may cause signal interfer-
ence, which may prevent the engine
from starting.
2. If the engine starts, turn it off and
try starting the engine with the
standard keys.
3. If one or both of the standard keys
do not start the engine, take the
vehicle, the code re-registering
key and both standard keys to a
Yamaha dealer and have the stan-
dard keys re-registered.
If the display indicates any error codes,
note the code number, and then have a
Yamaha dealer check the vehicle.
INSTRUMENT AND CONTROL FUNCTIONS
CAUTION:
If the display indicates an error
code, the vehicle should be checked
as soon as possible in order to avoid
engine damage.
Brightness control mode
1. Tachometer panel
2. LCD
3. Tachometer needle
The brightness can be adjusted for the
following:
G
the tachometer panel (item num-
ber "1")
G
the LCD (item number "2")
G
the tachometer needle (item num-
ber "3")
3-7
ECA11590
Select the brightness control mode as
follows.
1. Turn the key to "OFF".
2. Push and hold the "SELECT" but-
ton.
3. Turn the key to "ON", and then re-
lease the "SELECT" button after
five seconds.
Item number "1" is displayed.
1. Tachometer panel
2. Item number
3. Brightness level
4. Adjust
the
brightness level by pushing the
"RESET" button.
5. Push the "SELECT" button to se-
lect the LCD.
Item number "2" is displayed.
3
tachometer
panel
Advertisement
Table of Contents
Troubleshooting
