Maintenance; Recommended Maintenance Schedule - Toro 30582 Operator's Manual

Maintenance

Note: Determine the left and right sides of the machine from the normal operating position.

Recommended Maintenance Schedule

Maintenance Service
Interval
After first 10 hours
After first 50 hours
Every 50 hours
Every 100 hours
Every 200 hours
Every 400 hours
Every 800 hours
Every 1000 hours or
every 2 years,
whichever occurs first
Important
Refer to your engine operator's manual for additional maintenance procedures.
Maintenance Procedure
• Check the fan and alternator belt adjustment.
• Torque the wheel lug nuts.
• Check the cutting unit drive belt adjustment.
• Change the engine oil and replace the filter.
• Replace the hydraulic filter.
• Torque cylinder head bolts and adjust valves.
• Check the engine RPM (at idle and full throttle).
• Change the planetary gear drive fluid.
• Lubricate all grease fittings.
• Inspect the air filter, dust cup, and baffle.
• Clean under the cutting unit belt covers.
• Check the cutting unit drive belt adjustment.
• Change the engine oil and replace the filter.
• Check the fan and alternator belt tension.
• Inspect the cooling system hoses.
• Service the air filter.
• Torque the wheel lug nuts.
• Replace the fuel/water separator filter and the fuel filter.
• Check the battery level and cable connections.
• Replace the hydraulic filter.
• Adjust valves.
• Check the engine RPM (at idle and full throttle).
• Inspect and adjust fuel injection nozzles
• Change the planetary gear drive fluid.
• Check the rear wheel toe-in.
• Change the brake fluid.
• Change the injection pump filter.
• Change the thermostat.
• Replace the safety switches.
• Flush the cooling system and replace the hoses.
• Drain/flush the fuel tank.
• Change the hydraulic oil.
• Torque cylinder head bolts.
35