Mitsubishi Electric MSZ-FH25VE - E1 Service Manual page 42

Fixing the indoor coil thermistor
There are 2 forms of parts for fixing the indoor coil thermistor.
Clip shape
Position and procedure for mounting the clip-shape part
1. Set the indoor coil
thermistor in the center
of the clip-shape part.
NOTE:
Take care to avoid loss and accidental falling of the clip-shape part inside the unit.
Mount the clip-shape part on the marked position.
Do not pull the lead wire when removing the indoor coil thermistor.
© Copyright 2012 MITSUBISHI ELECTRIC CORPORATION
Distributed in Nov. 2015. No. OBH623 REVISED EDITION-D
Distributed in Jul. 2014. No. OBH623 REVISED EDITION-C
Distributed in Dec. 2013. No. OBH623 REVISED EDITION-B
Distributed in Mar. 2013. No. OBH623 REVISED EDITION-A
Distributed in Jul. 2012. No. OBH623
Made in Japan
OBH623D
Holder shape
HEAD OFFICE: TOKYO BLDG., 2-7-3, MARUNOUCHI, CHIYODA-KU, TOKYO 100-8310, JAPAN
When fixing the indoor coil thermistor
to the clip-shape/holder-shape part, the
lead wire should point down.
About the
same length
2. Check the (marked)
mounting position.
New publication, effective Nov. 2015
Specifications are subject to change without notice.
42
3.Mount the
clip-shape part.