Table of Contents
Advertisement
tools required (not included):
1/2" (13 mm) open-end wrench
1/2" (13 mm) socket or 1/2" (13 mm) wrench
Hardware (Included with your machine):
1 Handle (F)
1 Leg Assembly (DD)
4 Bolts (EE)
8 Flat Washers (FF)
4 Nuts (GG)
1. Remember to secure/support the machine before removing or
loosening the bolts. Use the wrench and socket to remove the
leg assembly bolts (EE, GG).
2. Position/slide the handle (O) into the frame (F) and on the out-
side of each side of the foot bracket assembly (DD).
3. Align the holes in the Handle with the mounting holes in the
frame and leg assemblies.
4. Fasten the handle (O) to the foot bracket (DD) and frame (F) with
the hardware (EE, FF, GG) from step 1 as shown and tighten
each nut until snug.
FF EE
FF
EE
O
GG
F
FF
FF
GG
DD
5. Attach high-pressure
hose (P) to spray gun.
Make
sure
it
is
secure.
6. Connect wand (E) to
spray gun. Make sure
connection is secure.
7. Place the grommets (B) onto the panel assembly (A) and push into
place.
A
8. Remove the five colored quickconnect nozzles from the plastic
bag and insert them into correct grommet on the nozzle holder.
Nozzles are color coded to match colored nozzles on panel
assembly.
note: The high-pressure pump was filled with oil at the factory.
Always check oil level before using (refer to Maintenance for more
information).
WARNING: Risk of bursting. Use a tire pressure gauge to check the
tires pressure before each use and while inflating tires; see the tire side-
wall for the correct tire pressure.
note: Air tanks, compressors and similar equipment used to inflate
tires can fill small tires similar to these very rapidly. Adjust pressure
regulator on air supply to no more than the rating of the tire pressure.
Add air in small increments and frequently use the tire gauge to
prevent over inflation.
11
P
E
B
Advertisement
Table of Contents
