Panasonic PT-FW430E Operating Instructions Manual page 67

TEMP indicator
J
Lights in red while projecting. ([REFER TO THE "TEMP indicator" SECTION IN THE
z
Indicator OPERATION MANUAL] appears on the screen.)
Blinking in red when the power is off. (Projection stops automatically.)
z
Status The internal or external temperature is abnormally high.
Is the ventilating
Check port (intake/exhaust)
blocked?
Remove the obstacles
Remedy from the intake and
exhaust ports.
Note
Clean the air filter unit when <TEMP indicator> persists to light or flash after taking above remedies. Contact to your dealer
z
when <TEMP indicator> persists to light or flash after cleaning the air filters.
FILTER indicator
J
Lights in red. ("Clean the air filter" appears on the screen)
z
Blinking unusually fast in red while the power is off. (Projection stops
z
Indicator
automatically.)
Status The internal or external temperature is abnormally high.
Is the ventilating
port (intake/
Check
exhaust)
blocked?
Remove the
obstructions from
Remedy
the intake and
exhaust ports.
Note
If <FILTER indicator> persists to light or blink after taking these measurements, please contact your dealer for repair
z
services.
TEMP, LAMP and FILTER Indicators
Is the temperature of
the environment too
high?
Place the projector
in the environment
with temperature and
humidity designated in
the specifications.
( page 84)
Æ
Is [HIGHT ALTITUDE MODE]
properly set?
• You can operate the projector for
only two minutes after the power is
turned on. If you use the projector
at an altitude from 1400 m (4593
ft) to 2700 m (8858 ft) above sea
level, set [HIGH ALTITUDE MODE]
to [ON] within the two minutes.
• Do not use the projector at an
altitude of 2700 m (8858 ft) or
higher above sea level.
( page 55)
Æ
Is [HIGH ALTITUDE MODE] properly set?
You can operate the projector for only two
minutes after the power is turned on. If you
use the projector at an altitude from 1400
m (4593 ft) to 2700 m (8858 ft) above sea
level. Set [HIGH ALTITUDE MODE] to [ON],
in two minutes.
Do not use the projector at an altitude of
2700 m (8858 ft) or higher avobe sea level.
( page 55)
Æ
Is the air filter unit
dirty?
Please perform
maintenance of
the air filter unit.
( page 68)
Æ
Blinks in red.
(The projection
automatically
stops after ten
minutes)
Air filter unit is not
attached.
Is the air filter unit
attached?
Please attach air
filter unit.
( page 69)
Æ
67
ENGLISH -