Sharp KB-3411JS Supplemental Service Manual page 30

KB-3411JS
KB-3411JK
KB-3411JW
OVEN DOOR ASSEMBLY REMOVAL
1. Disconnect the power supply cord.
2. Open the door to the fully opened position (Fig. O-1).
3. Pull the lock located on both hinge supports up and engage in the hook
of the hinge levers. You may have to apply a little downward pressure
on the door to pull the locks fully over the hooks (Fig. O-2).
4. Grab the door by the sides, pull the bottom of the door up and toward you
to disengage the hinge supports. Keep pulling the bottom of the door
toward you while rotating the top of the door toward the range to
completely disengage the hinge levers (Fig. O-3).
5. Proceed in reverse to reinstall the door.
6. Make sure the hinge supports are fully engaged before unlocking the
hinge levers.
OVEN DOOR RECEPTACLE HINGE AND HINGECOVER
REPLACEMENT
1. Disconnect the power supply cord.
2. Refer to the disassembly instructions as previously stated.
3. Remove (2) screws from Hinge Cover (Fig. O-4)
4. Remove Hinge Receptacle.
5 Proceed in reverse to reinstall the Hinge Receptacle and Hinge Cover.
Recepticle Hinge
OVEN DOOR REMOVAL
Fig. O-4
Recepticle Hinge
Hinge Cover
28
Fig. O-1
Fig. O-2
Fig. O-3