Sharp MD-M1 Operation Manual page 20

(Continued)
Preset tuning
You can store up to 40 stations in memory (40 sta-
tions consisting of any combination of AM and FM
stations you like) and recall them.
2,4
To enter stations into memory:
1
Perform steps 1 - 5 in the "Tuning" section.
2
Press the MEMORY button.
MEMORY
MEMORY
3
Within 5 seconds, press the PRESET (X or W)
button to make the preset channel number flash
in the display.
MEMORY
Store the stations in memory, in order, starting
with preset channel 1.
When is displayed, a station has already been
stored in this preset number memory.
4
Within 5 seconds, press the MEMORY button
to store that station in the selected station pre-
set number memory.
MEMORY
MEMORY
If the "MEMORY" and preset number indicators
go out before the station is memorized, repeat
the operation from step 2.
5
Repeat steps 1 - 4 to set other preset stations,
or to change a preset station.
When a new station is stored in the selected sta-
tion preset number memory, the contents previ-
ously memorized will be erased.
3
3
2,4
19
To recall a memorized station:
Press the PRESET (X or W) button for less than
0.5 seconds to select the desired station.
"MEMORY" will appear.
The stations (preset channel number, frequency
and frequency band) which have been stored in
memory will appear in the display in numerical
order, irrespective of the frequency bands.
Backup function:
The backup function protects all station presets for
a few hours should there be a power failure or the
AC power cord is removed from the AC outlet.
Preset memory scan
The stations saved in the preset memory can be
scanned automatically.
PRESET
(X W)
1
To scan the preset stations, press the PRESET
(X or W) button for more than 0.5 seconds.
The station preset number will flash and the pro-
grammed stations will be tuned in sequentially,
for 5 seconds each.
2
Press the PRESET (X or W) button again to
stop the memory scan at the desired station.
Note:
When the preset memory does not have any sta-
tions stored in it, the preset memory scan will not
function.
To erase all memorized stations:
When the unit is in the stand-by mode, hold and
press the TUNER and TUNING X buttons, and then
press the POWER button.
"PRESET CLR" will appear.
To erase the memorized station:
1
Recall the memorized station to erase by press-
ing the PRESET button.
2
Press the CLEAR button.
"MEMORY" and preset number will flash.
3
Within 5 seconds, press the MEMORY button.
4
Repeat steps 1-3 to erase other memorized sta-
tions.
PRESET
(X W)