Rear Terminal - Sanyo PLC-XP200L Owner's Manual

Rear Terminal

q
w
e
r
t
q COMPUTER INPUT TERMINAL (DIGITAL)
Connect the computer output digital signal to this
terminal. The HDTV (HDCP compatible) signal can
also be connected (pp.22-23).
w COMPUTER INPUT TERMINAL (ANALOG)
Connect the computer (or RGB scart) output signal
to this terminal (pp.22-23).
5 BNC INPUT jACKS
e
Connect the component or composite video output
signal from video equipment to VIDEO/Y, Pb/Cb,
and Pr/Cr jacks or connect the computer output
signal (5 BNC Type [Green, Blue, Red, Horiz. Sync,
and Vert. Sync.]) to G, B, R, H/V, and V jacks (pp.22-
23).
VIDEO INPUT jACK
r
Connect the component or the composite video
output signal from video equipment to this jack
(p.23).
t R/C jACK
When using the wired remote control, connect the
wired remote control to this jack with a remote
control cable (not supplied).
y
USB CONNECTOR (Series B)
y
Use this connector when controlling a computer
with the remote control of the projector. Connect
the USB terminal of your computer to this
connector with the supplied USB cable (p.22).
CONTROL PORT CONNECTOR
u
When controlling the projector from a computer,
connect the computer to this connector with a
control cable (p.22).
i AUDIO IN II jACK
Connect the audio output (stereo) signal from a
computer or video equipment (p.24).
S-VIDEO INPUT jACK
o
Connect the S-VIDEO output signal from video
equipment to this jack (p.23).
!0 AUDIO IN I jACK
Connect the audio output (stereo) signal from a
computer or video equipment (p.24).
Part Names and Functions
!0
o
i
u
11