Honda ST50 Shop Manual page 110

I 08 CT70 '80 ADDENDUM
8. OIL SEAL INSTALLATION
Drive 1he oil seal into position until the snap ring
groove appears.
Install the snap ring and dustcover.
9. FILLING WITH FORK OIL
Use ATF (Automatic Transmission Fluid) to fill the
front fork.
NOTE
Pour in the specified amount of ATF. Do not
overfill.
OIL CAPACITY : S2.S~S7.S cc (1.85~2.03 ozs.)
at disassembly.
Slide the front fork spring and spring seat into
position and tighten with the spring retainer bolt.
NOTE
• Place the fork tube in soft jaws, avoiding the
sliding surfaces.
• Note the spring direction.
10. FRONT FORK INSTALLATION
Install tl1e fork tubes in the fork top and bottom
bridges while rotating them by hand.
Ensure that each tube bears against the fork top
bridge.
Tighten the right and left fork bolts to the specified
torque.
TORQUE SPECIFICATION:
7.0-9.0 kg-m (S 1-6S ft-lb)
Tighten the front fork bolts at the fork bottom
bridge.
TORQUE SPECIFICATION:
1.8-2.S kg-m (13-18 ft-lb)
Install the front wheel.
FORK SEAL
DRIVER BODY
F
AK SEAL
DRIVER ATT.(A)