How To Remove/Attach Parts; Height Adjustable Upper And Middle Shelf; Door Pocket; Fixed Shelf - Hitachi R-X670GE Instruction Manual

HOW TO REMOVE/ATTACH PARTS

● Before removing parts, take out all the foods on the parts.
Caution
● Do not remove parts except the ones listed here.
Lift up the door pocket while tapping the left/right of its bottom surface, and remove it.
(It is fixed a little tightly.)
Caution
Draw the shelf, and pull off the 2 pins on the
lower right and remove it.
How to remove
Pull out the Vacuum Case by slightly
lifting up and moving up and down.
32
Please contact with a Hitachi customer service centre for cleaning such parts after removing them.
Insert the door pocket fully to the end when installing it.
If it drops, it may break and cause bruise or injury.

Fixed shelf

Forks

Height adjustable upper and middle shelf

Slightly lift up the back
of the shelf and draw it.
Forks of the shelf (Right / Left)
Upper
shelf
Middle
shelf
When installing the shelf, slide it until it reaches to the interior wall, then slightly lift up
the back of the shelf and push it in.
(hitch the forks of the shelf to the parts on the back of the shelf)
Door may be damaged if you draw the shelf without turning it.
Notice
Be careful to attach/remove the glass shelf because it is heavy.
If it drops, it may break and cause bruise or injury.
Request
Before removing the upper shelf, remove the middle shelf.

Door pocket

Remove the shelf by slightly lifting up the rear of
the shelf.
Caution

Vacuum Case

How to attach
Insert the Vacuum Case so that both
right and left convex ribs on the case
can slide under the guide rail of the
Vacuum Container.
Lastly, hold down the handle to lock.
Request
Check if it is fixed properly by taking it in and out a few times.
Raise the shelf,
as shown in the
drawing.

Height adjustable lower shelf

If you pull out the shelf straight, it may hit the door.
Vacuum Container
Convex rib
Rotate and
remove it.
Tap
Tap
Guide rail
Vacuum Case