Panasonic SF4D Series Instruction Manual page 78

Adjustment
<When mounting bracket is installed>
● Beam adjustment mounting bracket, Compatible bracket
Loosen the four hexagon socket head bolts with washers [M4 (length: 8mm), width
across flats: 3mm] that hold the mounting bracket in place, and rotate the emitter and
receiver to adjust the angle.
The angle of the emitter and receiver can be finely adjusted within the range of ±45°.
● No dead-space beam adjustment mounting bracket
Loosen the hexagon-socket head bolt (M5, silver) for beam adjustment on the
mounting bracket, and rotate the emitter and receiver to adjust the angle.
The angle of the emitter and receiver can be finely adjusted within the range of ±7.5°.
● Do not remove the hexagon-socket head bolt (M5, silver) for beam adjustment from this product.
● If it is still difficult to rotate the emitter or receiver even after the hexagon-socket head bolt (M5,
silver) for beam adjustment is loosened, loosen the hexagon-socket head bolt [M5] or hex bolt
[M6] securing the no dead-space beam adjustment mounting bracket on the mounting surface.
78
Hexagon-socket head bolt (M5,
silver) for beam adjustment
45° 45°
7.5°
CAUTION
© Panasonic Industrial Devices SUNX Co., Ltd. 2017
7.5°
This device
No dead-space beam
adjustment mounting
bracket