Sharp SWD-78EHL-SL Service Manual page 18

14.2 Remove the door hinge plate by unscrewing 3 bolts, remove the door rope then remove the
door.
14.3 Unscrew the bolts for middle panel from the front and back, then take off the middle panel.
14.4 Take off the top front panel by unscrewing 2 bolts. NOTE: The top front panel has wires connect
with the dispenser, hang it on the dispenser properly to avoid damage of wires.
14.5 Take out the water tap by tipping over unclockwisely.
14.6 Pull off the silicone tubes.
14.7 Connect the silicone tubes into the new taps with water as lubrication. CAUTION: Do not twist
the tubes.
14.8 Check the tubes make sure no twisting then Press down the new water taps into the grooves
firmly.
14.9 Install the top front panel back, then connect the tap pusher and tap stick in place. CAUTION:
Do not forget to install the tap pusher and tap stick!
14.10 Install the middle panel and door back.
15. Change top cover
15.1 Remove 2 bolts on the back then take off the top cover by gentle hitting from the back with hand
(there are 2 hooks at the front).
15.2 Change a new top cover, align the tap buttons with the holes on the top cover before closing on.
15.3 Press down the top cover in place, then screw on 2 bolts from the back.
16. Change top front panel assembly
16.1 Remove 2 bolts on the back then take off the top cover by gentle hitting from the back with
hand(there are 2 hooks at the front).
16.2 Remove the door hinge plate by unscrewing 3 bolts, remove the door rope then remove the
door.
16.3 Unscrew the bolts for middle panel from the front and back, then take off the middle panel.
16.4 FOR MODEL WITHOUT DISPLAY: Unscrewing 2 bolts of the front top panel, then take off the
panel gently. CAUTION: there is wire connect between the top front panel and water dispenser.
Take out the LED light assembly from the top front panel assembly. FOR MODEL WITH LCD
display: Take of the IMD panel assembly first, and unplug the wires, then take off the front top
How to change parts
page 21