Troubleshooting - Ghost Controls AXWK Manual

TROUBLESHOOTING:

QUESTIONS
After entering my PIN, any key would open/close the gate.
I did not enter a PIN, but any key would open/close
the gate.
Why are none of my keypad keys illuminated?
I entered a PIN, the gate opener beeps 1-time but
will not open.
I entered a PIN, the gate opener beeps 2-times but
will not open.
I entered a PIN, the gate opener beeps 2-times but
will not close.
When I press any key, the keypad gives 3 long beeps
follow by 2 short beeps.
The keypad gives 2 long beeps with all the LEDs flashing
twice randomly or when I use the keypad.
Do I need to reprogram everything when I change
the battery?
Can I have more than one keypad to control the
same gate?
Why did my keypad stop working? or My keypad worked
yesterday and now it does not work today?
ANSWERS
This is normal. After valid PIN is entered and send, any
number key on the keypad will operate the gate until the
keypad returns to Standby Mode.
Make sure the '1-Key' button LED (Green) is not on. If
it is, then the keypad is in '1-Key' mode. To disable 1-key
mode, press the '1-key' button, enter the PRIMARY PIN
and press the SEND button. The '1-Key' button LED
should turn off. Wait 60 seconds and test. If still in "1-Key"
mode remove one C battery and wait 15 seconds reinstall
battery and retest.
Keypad is in .
Standby Mode
In Standby mode, the keypad LEDs are not lit up and the
keypad requires the PRIMARY PIN or an ACCESS PIN to
be entered.
When PRIMARY PIN is used the PartyMode, 1-Key and the
Vacation Mode LEDs will be blinking in alternating sequence.
The PIN you entered is invalid. The 1-beep means the gate
'sees' the signal but the PIN is invalid.
VacationMode is enabled on the gate. See
or turn the gate controller OFF
ABLE VACATIONMODE
then back ON.
PartyMode is enabled on the gate. See
or turn the gate controller OFF
DISABLE PARTYMODE
then back ON.
The keypad is still in factory default setting. Please go to
'PROGRAMING THE KEYPAD FOR THE 1ST TIME'
complete the steps.
The keypad is performing a power on check when battery
1st installed. Check and change the batteries if necessary.
NO
YES
Replace two C-size batteries in keypad.
© G h o s t C o n t r o l s 2 0 2 1
ENABLE/DIS-
ENABLE/
and
9