Sealey AK468DXP Instructions

Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these
instructions, and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
Refer to Wear eye
instructions protection
1. SAFETY
Replace damaged parts. Use recommended parts only. Unauthorised parts may be dangerous and will invalidate the warranty.
9
Keep the drainer clean, dry and in good condition for best and safest performance.
9
Wear appropriate protective clothing and eye protection.
9
If it is necessary to raise the vehicle ensure that it is properly supported. If the vehicle has been raised with a jack, axle stands must
9
be put in place before working under the vehicle.
Remove the oil drainer and other tools and equipment from underneath the vehicle before lowering it again.
9
Use drainer in a suitable work area. Keep area clean and tidy, and free from unrelated materials and ensure that there is adequate
9
lighting.
The work area should have a flat and level surface capable of supporting the weight of the drainer and it's contents.
9
DO NOT position the drainer in such a way that it becomes a hazard to others in the work area.
8
Ensure that the floor is not slippery and wear non-slip shoes.
9
Keep children and unauthorised persons away from the work area.
9
Dispose of waste liquids in accordance with local authority regulations.
9
WARNING! DO NOT allow uncontrolled discharge of fluids which would pollute the environment.
‰
DO NOT use the drainer in wet or damp areas or where condensation is present.
8
DO NOT use the drainer near open flames or other sources of heat.
8
WARNING! If draining the oil whilst hot, take precautions to prevent against burns, particularly hands, wrists and arms.
‰
2. INTRODUCTION
Low level drainer suitable for use on the forecourt and workshop floor. High impact polypropylene fabricated unit with a capacity of 64L. Fitted
rotary pump and 2.4m hose for fast discharge. Fully portable with four castor wheels and handle for manoeuvring around the workshop.
3. SPECIFICATION
Model No:............................................................AK468DXP
Capacity: .......................................................................... 64L
Gravity Discharge: ........................................................... Yes
Gravity Feed: ................................................................... Yes
Maximum Height to Pan: ............................................ 250mm
Pump Discharge: ............................................................. Yes
Suction Probe: .................................................................. No
4. ASSEMBLY
4.1. Refer to parts diagram.
4.2. To mount the handle (3) and pump (18), you will need to partially disassemble the rear mounting plate (9).
4.3. Remove right castor wheel nut (5) from castor (23) and slide out the mounting plate (9).
4.4. Attach handle (3) to mounting plate (9) using screw (8).
4.5.
Attach pump (18) via the mounting bracket to the mounting plate (9) using the nuts and bolts provided.
4.6. Re-attach mounting plate (9) and right castor.
4.7.
Attach short hose (12) to connector (11) on bottom of pump (18) and bottom of reservoir (7) with hose clamp (14).
4.8. Attach long hose (24) to connector (11) on top of pump (18) with connector (11).
© Jack Sealey Limited
64L LOW LEVEL OIL DRAINER WITH PUMP
MODEL NO:
Wear protective Wear protective
gloves clothing
Original Language Version
AK468DXP
AK468DXP Issue 1 06/01/2021