Adjusting Height; Installing The Side Trim Strips - Blomberg DWT25504SS Installation Manual

A

6.3 ADJUSTING HEIGHT

If the height of the enclosure is 337/8" to 357/8"
(861 mm - 911mm) adjust supports as shown in
the figure.
Supplied (4)
Adjust the front foot level with the adjusting
wrench to balance and raise the dishwasher to the
enclosure height.
Adjust the rear foot level with a screwdriver to
balance and raise the dishwasher to the enclosure
height.
NOTICE :
• Make sure the dishwasher is plumb and
notice dishwasher can be placed with a small
clearance under the counter top.
• Turning the screwdriver in the direction of the
black arrows will bring the dishwasher back feet
up.
• Turning the screwdriver in the direction of the
white arrows will take the dishwasher rear feet
down.

6.4 INSTALLING THE SIDE TRIM STRIPS

Remove the adhesive tape (Figure A).
Place the trim strips on the front edge of the side
walls (Figure B).
NOTICE :
• Make sure you use the correct trim strip since
there is a left and right side strip. The flexible
material should be facing forward (Figure B).
B
10
USA