Advertisement
4. OPERATION
4.1.
ATTACHING AND REMOVING THE NOZZLE
DO NOT press the Nozzle or pull on the edge of the Nozzle by pliers.
8
4.1.1.
Push the nozzles into position. Note: Try to use nozzles with a larger diameter.
WARNING! Wait for nozzle to completely cool before removing it.
‰
4.2.
OVERHEAT PROTECTION
4.2.1.
Power will automatically be off when the unit exceeds a certain temperature. Once the temperature has dropped to a safety level,
power will automatically be turned on.
4.3.
Connect the mains plug to a socket.
4.4.
Turn on the power switch, set the air flow rate and temperature and put the unit on the rack.
4.5.
Put the nozzle on the pins of the Integrated Circuit, so that the hot air can melt the solder tin on the Integrated Circuit pin, then use
the tweezers to remove the Integrated Circuit.
4.6.
After use, turn off the power switch, remove the plug from the power supply and allow to cool before storing in a safe place out of
children's reach.
4.7.
The display and temperature setting
4.8.
Press the button "+(UP)" or "-(DOWN)"to adjust the temperature.
Short press, the set-point will change ±1°
Long press, the set-point will change quickly and reach your target temperature.
4.9.
"°C/ °F" is the transfer button between °C/ °F
The default unit is °C, press the "°C/ °F "button to make change between °C and °F.
4.10.
The air flow rate can be adjusted by the knob under the fan symbol.
When you rotate the knob to the DOWN - side, the air flow slows down;
When you rotate the knob to the UP + side, the air flow goes up;
4.11.
This unit has sleep function.
When you put the air pump on the rack, the item will stop heating, And the display shows"SLP"( means SLEEP), when you pick
up the air pump , the item will get back to the set temperature.
4.12.
WASHING
4.12.1.
When de-solder is completed, please wash away the flux.
NOTE: While you de-solder by Hot air, the defects such as solder balls, solder bridges might occur. We recommend you to examine the
condition of the soldering.
ENVIRONMENT PROTECTION
Recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be sorted, taken to
a recycling centre and disposed of in a manner which is compatible with the environment. When the product becomes completely
unserviceable and requires disposal, drain any fluids (if applicable) into approved containers and dispose of the product and fluids
according to local regulations.
WEEE REGULATIONS
Dispose of this product at the end of its working life in compliance with the EU Directive on Waste Electrical and Electronic Equipment
(WEEE). When the product is no longer required, it must be disposed of in an environmentally protective way. Contact your local solid
waste authority for recycling information.
Note: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior
notice.
Important: No Liability is accepted for incorrect use of this product.
Warranty: Guarantee is 12 months from purchase date, proof of which is required for any claim.
Sealey Group, Kempson Way, Suffolk Business Park, Bury St Edmunds, Suffolk. IP32 7AR
01284 757500
© Jack Sealey Limited
01284 703534
sales@sealey.co.uk
Original Language Version
www.sealey.co.uk
SD007 Issue 1 28/01/2021
Advertisement
