Advertisement
8.
Maintain the forward speed of the Workman
cle and the working width used in the calibration of
the spreader.
WHEN THE JOB IS COMPLETED:
IMPORTANT: On the spreaders equipped with the
optional flow control kit, cover or otherwise protect
the electric actuator and limit switches, while using a
high pressure washer hose to clean the spreader unit.
Water entering the actuator, or the limit switches,
will cause serious damage and premature failure of
those parts.
1.
Close the regulator disc, using the flow control han-
dle or the toggle switch on the control box.
2.
Operate the spreader drive slowly, while spraying
water inside the hopper.
3.
Open the regulator disc and spray the agitator and
regulating plate.
4.
Spray all of the outside surfaces of the spreader.
MAINTENANCE
®
vehi-
AFTER THE INITIAL RUN-IN PERIOD (APPROXI-
MATELY 5 HOURS):
1.
Remove the drive cover.
2.
Grease the two (2) fittings in the U-joint assembly.
Grease after every 250 hours thereafter.
3.
Grease the zerk fitting in the underside of input
shaft hub.
4.
Remove the plug and check to see that there is oil
visible in the gear multiplier unit. If oil is needed,
add lubricant #5555 or equivalent.
5.
Replace the drive cover.
NOTE: Two access doors are provided in the frame's
engine cover, on each side of the drive cover, to allow
servicing of the Workman
drive cover for access to the engine's oil fill cap.
®
. Remove the plug under the
7
Advertisement
